Classic Car flush fitting dashboard clock

A great little accessory – cover unsightly holes on your dash or fills an empty space and at the same time looks the part, works and easy to fit ……..

With a 40mm outside diameter and only 7mm deep you can position it anywhere on your dashboard where there is a suitable gap.A quality looking gauge with a polished steel surround on a steel casing – no plastic.

Fitting Instructions
Quick and Easy Fitting – no holes to drill, so no damage to the dashboard.
Simply fix using the double sided adhesive pad. Alternatively use adhesive putty like bluetac.This makes it easier to remove to adjust the time and when the time comes to replace the battery. Also if you want to try different locations on the dashboard use a piece of bluetac (or equivalent). It only needs say 3 little balls of the putty about 2mm in diameter spread equally around the perifery of the back plate to hold the clock in place.

Buy at
See the item to buy on eBay at

To adjust the time simply pull the button on the side just a millimetre and turn to suit. Then push the button back. Best to set the time before fixing with the adhesive tape.To change the time when fitted simply put your fingers around the rim of the clock and gently pull. The rim with the clock will come away leaving the backplate attached to the dash board. This makes it easier to change the time and battery.