MGB rear axle overhaul – Part 1 – disassembly

As I already wrote in an earlier post last November – my MGBs rear axle was in the paint-shop that … More

Diff Cover Repair

When putting the diff back together i was aware that i had to do a better job of sealing the … More

Earlier in the year I replaced the diff washers to stop the diff clonk but they did not stop it … More

Whilst the fuel tank was out thought an ideal opportunity to replace the fibre washers in the diff. Had replaced … More

Some useful information that applies to drive shafts, half shafts and steering columns that i found on the mgexp.com website … More

To get to the diff to change the thrust washers one of the half shafts needs to be removed. Read … More

Got the new kit in place – the only piece that was still in existence to remove was a wafer … More

I removed the diff cover prior to removing the drive half shaft so i could see how much play there … More

To measure the slack prior to taking the diff apart I locked the prop shaft and the opposite drum and … More

All ready to do a few jobs under the back of the car, the main one being to replace the … More

An interesting post on the MGB Register forum discussing how much slack you can have in the rear axle before … More

Chicagoland MG Club:Photos Chicagoland Mg Club:Members Just saving this article ready for my next winter project – should able to … More