A job I should have done when the engine was out and replaced the clutch. I thought would be a … More
Category: Clutch
Clutch Pedal Slop
After some suggestions on the MGOC forum as to my the clutch bite point seems very close to the floor … More
A Handy Little Helper
I have just replaced the clutch master cylinder and I wanted to see how much the slave cylinder was moving … More
Replacement Clutch Master Cylinder
A squeak that pulsed with the revs of the engine restarted recently. I thought i had fixed it thinking it … More
The little bleeder
Just a FYI. Aftermarket suppliers send the slave cylinder with the bleeder in the “wrong hole”. Hose should be on … More
MGB Clutch Upgrade | Bradley Restoration
For those of you who have upgraded your engine output, by over-boring or even supercharging, there is a simple upgrade … More
MGB Clutch Upgrade | Bradley Restoration
For those of you who have upgraded your engine output, by over-boring or even supercharging, there is a simple upgrade … More
Oiling Clutch Thrust Bearing Pivots in Situ
I was getting a like whistling / squeaking sound coming from the clutch when the engine had warmed up but … More
Degassing Clutch Hydraulics
I’ve never heard of this procedure before but it’s been described recently on the MGOC forum as a way to … More
Diagnosing Clutch Problems – Moss Motoring
Clutch problems fall into three categories: a) The clutch does not release properly when the pedal is depressed, resulting in … More
#MGB Clutch Slave Cylinder Replacement
I have just replaced the clutch slave cylinder as i suspected it may have been the cause of a sort … More
Checking Thrust Bearing in situ with endoscope.
I replaced the clutch and thrust bearing a year ago when I had the engine out. Just recently I’ve noticed … More
MGA/B Roller Release Bearing – Beware!!
There’s a lot of debate about these but I think this video makes a pretty conclusive case against using them. … More